HYDRO-OLEOPHOBIC PROTECTOR WET EFFECT IDEA XC

FOOD SAFE: Suitable for placing food on the treated surface.

Mode of use:

1. Preparation of the support: The surface must be dried and cleaned. Stains, fungi and various inlays must be completely removed, otherwise they will be encapsulated and protected by the resin film and their successive extraction would be difficult.

• Applicable with: Brush, roller, spray. Brush application is advisable, where possible, as it allows for better penetration of the guard, exerting a slight pressure to make it penetrate well into cracks, angles and cavities. It is possible to apply the guard using a spray gun, spraying 20-25 cm from the surface and taking care to plug possible holes.

1. Allow the product to air dry and the material to be protected. In the event that there are some leave after application, remove it using a damp cloth.

• During application and drying, the substrate temperature should be between 10 and 30°C. In case of application on floor with underfloor heating, switch off the heating and let the stone cool down completely.

Usage Tips:

• It is advisable to apply the product until the complete saturation of the stone.
• On highly absorbent materials it is advisable to apply the product 2 times with a 1 hour separation from the first
• Do not dilute the product with other solvents or water, as preparation is ready for use.
• The material to be treated must be completely dry.
• Another application system, suitable for small pieces, can be by immersion. It is also possible to use a wet sponge of the product and plug the material.
• Once treated, the lapideo material has to be allowed to dry for 24 hours for complete polymerization to occur.
• In the case of treatments on statues, vessels or exterior decoration items, make a lot of case to the intersticios.
• Before use, carefully read the recommendations on the label and make a preliminary test.

Safety measures: In addition to good working practice, please refer to the CE safety data sheets and follow the regulation on laws that discipline workplace safety.

Application surface: Marbles and granites, marble/cement, marble/resin, calcareous stones.

Usage Tool:

Product Performance: For the protection of marbles and bright or polished granites beyond the 800 grain, 15/25 m² can be treated with a lt. Of product. In the case of calcareous stones, sandstones, marble/cement, with a lt. 8/15 m² can be treated.