INSTANT MARBLE AND LIMESTONE POLISH GEL EUREKA

Mode of use:

FLOOR APPLICATION:

• Wash the pavement thoroughly with a single-cup machine and suitable disc, removing dirt, possible residues of old waxes and treatments (we advise the use of our ULTRA STRIPPER); rinse very well and dry with a liquid aspirator. Place a small amount (approximately 30 grams) of "Eureka" directly on the pavement, under the animal bristle disc, moisten lightly, then spread the product on approximately 1-2 m² of pavement with a single-wheel machine (150 turns/minute and 30 kg minimum weight). Nebulize or pour water in case the gel dries very quickly during processing. After distributing the product, work the surface until the gel dries, obtaining the desired shine.

In case of very porous materials it may be necessary to repeat the treatment a second time. When finished wash and rinse with water and an alkaline substance (soda, bicarbonate or our ULTRA STRIPPER detergent) to remove product residues and to neutralize residual acidity.

1. IMPORTANT TIP:

• The Bellinzoni Phoenix EH or Phoenix HDH monocoque is recommended because they are multi-purpose machines in terms of power, speed, attachments and efficiency, which allow the operator to perform much of the plant work on any material.

APPLICATION FOR TABLES, KITCHEN AND BATHROOM COUNTERS, BAR BARS ETC.:

• Surface preparation: The surface must be dry and clean. Wash the material to remove dirt, old wax residues and treatments (use of OUR ULTRA STRIPPER is recommended); rinse well and allow to dry. Place a small quantity (10-15 grams) on the surface to be treated, moisten with a few drops of water; put the EUREKA gel on the surface and polish using an orbital sander with variable speed at low speeds, between 800 -1500 rpm (1,000 rpm is optimal). Pass on the surface until the gel is completely dried and the result is tracked. Clean the debris with water and neutral detergent. If necessary, the entire procedure can be repeated.

1. IMPORTANT TIP:

• The Eureka Pad is recommended as it is made with a perfect balance between correct smoothness and homogeneous density, a relationship that improves Eureka Quarzo and allows it to reach the working temperature quickly.

Usage Tips:

• Do not dilute the product as it is ready for use. It is recommended to add water, only in the event of excessive dryness of the product.
• If the machine is difficult to build due to rubbing and relative overheating of the pavement, spray water in the required amount.
• During application and drying, the substrate temperature should be between 10 and 30°C. In case of application on floor with underfloor heating, switch off the heating and allow the stone to cool completely.
• Before use, carefully read the recommendations on the label and make a preliminary test.

Safety measures: In addition to good working practice, please refer to the CE safety data sheets and follow the regulation on laws that discipline workplace safety.

Application surface: Marble, calcareous materials.

Usage Tool:

Product Performance: With a product lt. 20/30 m² can be treated.

Maintenance: For floor maintenance we recommend the use of our detergent LEM-3.